They will periodically pass copies of the entire routing table. They become even slower, when you see how they exchange information with their neighbors. This makes them slower in understanding network changes and it also makes them rely on secondhand information, which also makes them inaccurate. In example, router would need to wait his neighbour routers to advertise to each other in chain. In that sense, they rely on sort of a chain reaction. The first criteria is how routers discover each other and the answer to that lies in the fact that distance vector protocols will rely on neighbors to tell them the direction or vector toward destinations and how far away those destinations are, and so a routing protocol like RIP will advertise to its neighbors and obtain the information directly from its neighbors, those routers running the same protocol. So let us analyze it according to our three criteria.

XSM7224S - firmware version 9.0.1.We are going to demonstrate the configuration of the RIP protocol, which belongs to the distance vector category.

This article applies to the following managed switches and their respective firmware: The following figure shows a network with RIP on ports 1/0/2 and 1/0/3.

Prevent any RIP packets from being sent.

Prevent any RIP packets from being received.

Send packets formatted for RIPv1 or RIPv2, or send RIPv2 packets to the RIPv1 broadcast address.

Receive packets in either or both formats.

You can configure a given port to do the following:

The routing table is sent to a multicast address, reducing network traffic.

Route specification also includes subnet mask and gateway.

The routing table is broadcast to all stations on the attached network.

Routes are specified by IP destination network and hop count.

There are two versions of RIP (the managed switch supports both): When a route is removed from the routing table, it is flagged as unusable by the receiving routers after 180 seconds, and removed from their tables after an additional 120 seconds. A router running RIP sends the contents of its routing table to each of its adjacent routers every 30 seconds. It is characterized as an interior gateway protocol, and is typically used in small to medium-sized networks. Routing Information Protocol (RIP) is a protocol that routers can use to exchange network topology information.

Lan setup rip version